Pops A Dent Vehicle Repair Kit with Large Glue Gun and Glue Sticks Damage Repair Tool Kit

1, Clean the dent portion; 2, Install the hot melt glue , pulled the trigger, let glue stick into the glue gun, plug in the power, let the glue gun warm up for 5 minutes; 3, To find a suitable traction pads (large dent need big traction gasket; (Note: the greater traction pads, traction tension greater); 4, Pull the trigger glue gun with glue painted extruded selected traction pads (4 hole gasket also painted hot melt adhesive) 5, Traction quickly painted hot melt adhesive gasket on the central part of the dent, gently press and hold until the hot melt adhesive curing cement; (make hot melt adhesive to dry for about 8 minutes; we recommend not to let heat melt glue drying time not more than 10 minutes) 6, The traction pull of holes in the middle of the bridge cement traction spacer bar, the screw rotating knob condom traction spacer bar, slowly tighten until the dent portion pulled flush with the surrounding surface can . 7, Some dents, may need to repeat these steps several times to fix the dent. 8,If the repaired surface raised a little, please follow the following steps: First, the projections point with the thumb rubbing back and forth until the projection point as with other flat surface; if the thumb can not make projections point lies flat, will use percussion stick (to hold a pen gesture) and gently click raised points raised points until flat. Sometimes you may need to repeat several times before they can. (Note: When using percussion stick, not force too much) 9, After the dent repair, unscrew the screw rotating knob to remove the traction pull the bridge, then remove the traction pads, if there are hot melt adhesive stick to the surface of the body, so that you can hand gently tear.